Technical Data - Beurer Profi-Set MP 30 Gebrauchsanleitung

H – cuticle pusher
Soften the cuticle with water or cuticle oil. Now you can push back or remo-
ve the cuticle. Depending on the sensitivity and stubbornness of the skin,
you can either use the soft, rounded side or the harder pointed side.
When filing, always work from the outside of the nail towards the tip!
Always check results regularly during treatment. As soon as the application
becomes unpleasant, stop the treatment.
4. Cleaning/care
Before cleaning the power unit, always unplug it from the socket outlet!
– Clean the instrument with a slightly moistened cloth. You can also
moisten the cloth with mild soap suds to remove more stubborn dirt.
– If necessary, for reasons of hygiene, the attachments can be cleaned with
a cloth or brush moistened with alcohol. Dry them carefully afterwards.
– Do not drop the instrument.
– Make sure that no water enters the instrument. But if this should happen,
do not use the instrument again until it is completely dry.
– Do not use chemical detergent or scouring agents for cleaning.
– Never immerse the instrument or plug-in power unit in water or other
liquids.

5. Technical data

Power unit voltage
Speed:
F – Flame milling cutter
For removing ingrowing nails. Carefully guide the flame
cutter up to the part to be treated and remove parts of
the nail as necessary.
G – Sapphire milling cutter, round
This accessory attachment is for the careful removal of
corns. When using this attachment, please remember
when removing the layer of skin from the corn that you
will quickly penetrate deeper into the skin and this could
injure the periosteum.
Input: 100-240 V AC / 50-60 Hz
Output: 2.6 V DC / 800 mA
9.000/14.000 U/min ±12%
14