Beurer Profi-Set MP 30 Gebrauchsanleitung Seite 11

– After use, before cleaning and changing any accessory parts, the power
unit should always be disconnected.
– This device is not intended for use by persons (including children) with
restricted physical, sensory or mental capabilities and/or by persons
lacking the required understanding of the equipment and how it is used,
unless they are supervised by a person who is responsible for their safety
or they are given instructions on how to use the device.
– Children should be supervised to ensure that they do not use the device
as a toy.
2. Preparation
2.1 Battery operation
Before using the appliance for the first time, charge the battery for at least
15 hours. To do this, connect the power unit to the mains supply. After
charging for the first time, charge time is approximately 7 hours. Turn off
the appliance when charging.
Connect the mains adapter cable to the jack on the appliance and plug the
adapter into the wall outlet. The LED indicator shows that the appliance is
charging.
After every charge, you can use the appliance for ~ 30 minutes.
Please note that you can best preserve the life of the rechargeable battery
by avoiding interruption to the charging cycle prematurely, and continuing
to operate the appliance until the battery is discharged.
Ensure that the mains adapter is unplugged from the mains power supply at
the end of the charging time.
2.2 Mains operation
If the battery is empty, the appliance can also be run using the plug-in po-
wer supply. To do this, let the appliance charge with the power unit for ap-
prox. 5 minutes; it will then be fully operational again. The appliance should
only be operated with the voltage indicated on the power unit.
2.3 What you should know about the appliance
This manicure and pedicure appliance is equipped with top-quality attach-
ments. It has a cuticle pusher and 7 attachments with a long-life sapphire
coating or polishing felt.
11