Troubleshooting - Abicor Binzel CAT2 Betriebsanleitung

CAT2

10 Troubleshooting

Risk of injury and machine damage when handled by
unauthorized persons
Incorrect repair work and changes of the product may lead to significant
injuries and machine damage. The product warranty will be rendered
invalid if the unit is handled by unauthorized persons.
• Operating, maintenance, cleaning and repair work may only be carried
Please observe the attached document "Warranty". In the event of any doubts
and/or problems, please contact your retailer or the manufacturer.
NOTICE
• Please also consult the operating instructions for the welding
Fault Cause
• Wrong torch mount used
Torch mount cannot
• Mounting flange of the CAT2
be mounted.
defective
• Cable between CAT2 and cable
assembly is not connected
CAT2 does not switch
• Cable defective
stop signal
• CAT2 switch housing defective
• Mounted load is too heavy
CAT2 does not reset
• Mechanical defect
to zero position
• Mounting parts (mount etc.) not fixed
correctly
Tab. 13
Troubleshooting
All manuals and user guides at all-guides.com
DANGER
out by qualified personnel (in Germany see TRBS 1203).
components, such as power supply, compressed air line.
10 Troubleshooting
Solution
• Use correct torch mount
• Send in the CAT2 for service
reparation
• Connect cable
• Replace cable
• Send in the CAT2 for service
reparation
• Reduce mounted load
• Observe the data of the
manufacturer
• Send in the CAT2 for service
reparation
• Check the fastening of the
mounting parts
EN - 21