Abicor Binzel CAT2 Betriebsanleitung Seite 40

6 Putting into operation
6.2 Adjusting TCP
 Fig. 6 Mount CAT2 on the robot on page EN-15
1 Loosen the nut (15) and adjust the torch mount (2) on the desired TCP.
2 Screw down the nut (15) and tighten it.
To fix the adjusted position proceed as follows:
1
2
Fig. 8
3 Drill the mount (4) with Ø 5.8mm and ream the bore for the dowel
screw (3) using a reamer.
4 Fix both mounts (4) and (2) using dowel screw (3).
6.3 Connect the helix cable
 Fig. 6 Mount CAT2 on the robot on page EN-15
1 Plug the helix cable (4) with a right angle plug on the connector
housing (5).
2 Plug the flange plug on the torch and cable assembly.
3 Lock both plugs against unintentional loosening.
For the switching function please see the functional diagram.
 Fig. 5 Functional diagram on page EN-13
6.4 Activating the LED function
The green LED shows a trouble-free operation of the CAT2 robot mount. In case
of collision the switching voltage is switched off and the LED goes out.
 Fig. 5 Functional diagram on page EN-13
1 Assign GND on PIN 1 on the plug.
EN - 18
All manuals and user guides at all-guides.com
1
5
Washer 3 Dowel screw 6H7
Torch mount 4 Mount
Adjusting TCP
2 3
4
5 Nut
CAT2