Cleaning Before Use; Changing The Door Hinges - hanseatic HEKS 12254 A1 Gebrauchsanleitung

Cleaning before use

To remove the odour that comes with all new
appliances, clean the appliance before use
(see „Cleaning the fridge compartment" on
page GB-11.

Changing the door hinges

You can change the side on which the door
opens. The stop is on the right on delivery.
As this alteration requires some manual skills,
please read through the work instructions be-
fore altering.
In addition to the package contents, you will
require
– a medium sized cross-slotted screwdriver,
– a pair of flat-nosed pliers,
– the assistance of another person, where
possible.
1. Ensure that the appliance is not connect-
ed to the power supply.
2. Remove the door compartments (7),
the vegetable drawer (8) and the glass
shelves (9) and (10).
B
3. Screw the strip (A) onto the top and put it
to one side.
4. Also unscrew the screw (B) on the new
stop side and keep it in a safe place.
All manuals and user guides at all-guides.com
A
C
Start-up
5. Loosen the three screws of the top hinge
(C), remove them and keep them in a
safe place.
6. Remove the door and set it aside.
7. Screw in the screw (B) on the previous
stop side.
8. Tilt the device slightly and rest it against
the wall.
D
9. Unscrew both feet.
10. Remove the pin (D) from one foot and
insert it into the other; the shorter side
goes in the foot.
11. Insert the foot with the pin (D) into the
designated recess from underneath and
screw the foot tight again.
12. Also screw the other foot tight.
13. Reposition the appliance upright.
14. Place the door over the pin (D) from
above and close it.
15. Now loosen the pin in the top hinge (C)
using flat-nosed pliers.
16. Re-insert the pin from the other side.
C
17. Screw the hinge (C) onto the new stop
side.
18. Then check the door sits correctly (see
„Checking and cleaning door seals" on
page GB-11).
Page GB-15