Deflating With The Pump Hose (Flexible Low Pressure Hose); Replacing Fuses - AEG MV 10 Betriebsanleitung

26
▪ Remove the valve adapter from the item's valve
and attach the item's valve cap.
▪ Then remove the flexible pump hose from the
compressor's inflating valve
Non-binding pressure guidelines
Automotive tyre approx. 1.9 – 3.5 bar
Trailer tyre approx. 2.4 – 3.4 bar
Motorcycle tyre approx. 1.7 – 2.9 bar
Bicycle tyre approx. 2.0 – 4.0 bar
Football approx. 0.6 – 1.1 bar
Volleyball approx. 0.18 – 0.22 bar
Attention! Please not the manufacturer
specifications for the item. Do not use the
compressor to inflate swimming aids!
4.5 Deflating with the pump hose
(flexible low pressure hose)
Deflating
Inflating
Image 9
▪ To deflate items open the item's valve cover.
▪ Attach the correct size valve adapter to the
flexible pump hose and press it into the item's
valve. If the valve adapter comes off the valve
whilst deflating, use your hand to press it into
the valve whilst deflating.
▪ Check the valve adapter is firmly seated in the
item's valve by carefully pulling on it.
.
15
▪ Now insert the free end of the flexible pump
hose onto the compressor suction valve
sure it is firmly seated.
▪ To switch the compressor on set the compressor
switch to ( I ). Note: the compressor can be
13
switched off at any time by setting the com-
pressor switch to ( O ).
13
▪ Once the item is deflated promptly switch the
unit off by setting the compressor switch to ( O )
and disconnect the unit from the power supply.
Avoid overloading the unit by suctioning an
already deflated item!
Do not operate the compressor longer
than 10 minutes, then allow the unit to
cool down for 10 minutes!

4.6 Replacing fuses

12 V automotive plug
Round fuse 15 A (Ampere)
Retaining screw
Terminal cap
Image 10
▪ Unscrew the retaining screw.
▪ Remove the terminal cap and the 15 A
(Ampere) round fuse.
▪ Reassemble all parts with the new 15 A fuse in
the order shown and replace the retaining
screw (see Image 10).
16
17
12 V plug
Vehicle
connector
. Be