Operation / Accessories; Powering The Equipment On / Off; Operating The Light; Operating The Compressor - AEG MV 10 Betriebsanleitung

4.0 OPERATION /
ACCESSORIES

4.1 Powering the equipment On / Off

▪ Remove the 12 V automotive plug
connector cable from the storage
compartment .
10
▪ Use the 12 V automotive plug
12 V receptacle of a vehicle or a suitable
power station with 12 V storage battery.
The equipment is now operational and the
lighting on the manometer
▪ To switch the compressor on set the On / Off
switch to ( I ).
13
▪ To switch the compressor off set the On / Off
switch 13 to ( O ).
Automatic start warning! If the
On / Off switch for the compressor
power is set to ( I ) before switching the
unit on, the compressor will automatically start
and compressed air will be supplied through the
air hose and to the inflating valve and air sucked
in through the suction valve. Risk of property
damage and personal injury!

4.2 Operating the light

▪ Set the On / Off switch for the light
The light with the 4 LEDs is now switched on.
▪ Turn the lamp head to swivel the light by
180 (see Image 5).
°
▪ To switch the LED light off set the On / Off
switch for the light
14
Image 5
with
17
on the
17
is activated.
1
to ( I ).
14
to ( O ).
Swivels
180
°
degrees

4.3 Operating the compressor

The unit may be connected to a vehicle using the
built-in 12 V automotive plug and a vehicle or
operated with a suitable separate power station
with built-in 12 V storage battery.
Attention! Always wear suitable ear
protectors and safety goggles during
operation!
Check the unit and compressed air hose
damage before every use! Do not operate dam-
aged units! Review the manufacturer instructions
for the item to be inflated before every use.
4.3.1 Use with the air hose and the
automotive valve connector
Select the desired valve adapter
Open the valve quick disconnect
the quick disconnect lever away from the air hose
3 . Now attach the valve adapter and press the
lever toward the air hose to close (see Image 6).
4
3
Image 6
Car, motorcycle- and bicycle tyres with auto-
motive valve (Schrader valve with 7.7 mm thread
diameter) can be inflated without adapter!
Do not operate the compressor longer
than 10 minutes, then allow the unit to
cool down for 10 minutes!
GB 23
for
3
, or .
7 8 9
by pressing
4
9
8
7