Commissioning And Temperature Setting - ArteVino oxygen OXG1T230NPD Gebrauchsanweisung

Commissioning and temperature setting

Commissioning
After waiting 48 hours, plug in your wine cabinet, having checked that your socket is
correctly supplied with power
(presence of correct sized fuses, circuit breaker in working order. If need be, plug in another electrical
appliance to check the power supply).
Humidity
Your cabinet is fitted with an exclusive ARTEVINO system allowing you to recreate inside your wine
cabinet the level of humidity required to effectively seal your bottles' corks. When installing your cabinet, it
is important to pour the equivalent of one glass of water onto the floor of the cabinet to reach an optimal
hygrometry rate.
Temperature setting
Description of the control panel
•
Status lights:
Compressor 1 : indicates that the compressor is operating. When this flashes, it means that the
compressor is going to start up in a few minutes (technical delay).
Defrosting cycle 2 + : indicates that an automatic defrosting cycle is underway.
Heater 3 : indicates that the heater is operating.
Alarm 4 : informs you that there is an abnormally high or low temperature inside the wine cabinet.
Commissioning the control panel
By default, the control is in the OFF position. To switch on the cabinet, press and hold the
several seconds until just the temperature is displayed.
To put the cabinet on standby, press and hold down the
between the internal temperature and the OFF display (the cabinet is no longer operating, only the display
is active).
To reactivate the cabinet back on, press and hold down the
temperature is displayed.
12
1
2
3
4
Temperature display: displays the actual temperature inside your wine cabinet. It is therefore
necessary to wait before your new setting takes effect.
button for several seconds. The display switches
button for several seconds until just the
button for