Some Important Facts About Wine; Power Supply; Installing Your Wine Cabinet - ArteVino oxygen OXG1T230NPD Gebrauchsanweisung

Some important facts about wine

Your ARTEVINO wine cabinet has been designed to guarantee optimal storage and/or serving conditions
for your wine.
Wine is a complex product. It develops very slowly and requires specific conditions in order to reach its
full potential.
All wines are stored at the same temperature. Only their serving temperatures differ.
This being the case, just like the natural cellars of wine producers, it is not so much the absolute value
of the storage temperature that is important but its consistency. In other words, whatever temperature
your cabinet is set at (between 10°C and 14°C for a maturing cabinet), your wine will be stored in ideal
conditions provided that this temperature does not fluctuate.
IN ANY EVENT, IF YOU NOTICE A HUMIDITY OR TEMPERATURE FAULT INSIDE
YOUR WINE CABINET, BE AWARE THAT ONLY PROLONGED EXPOSURE TO
ABNORMAL CONDITIONS IS HARMFUL TO YOUR WINES.

Power supply

For your personal safety, the wine cabinet must be correctly earthed.
Ensure that the socket is correctly earthed and that your installation is protected by a circuit breaker
(30 mA*)
*Not applicable to some countries.
All work must be carried out by a qualified electrician.

Installing your wine cabinet

• When unpacking your cabinet, check that it is not damaged (signs of impact, buckling, marks).
• Remove the protective elements found inside and outside your cabinet including the lower hinge
protector (see diagram (1))
• Fit the cap (see diagram 2), found in the accessories bag, used for sealing the hole in the lower hinge.
• Open the door and check that the various elements are intact.
Protective wedges for transportation have been attached to each shelf. 2 wedges per shelf (Picture 1).
Remove all of them using a rotating movement (Picture 2). You can retain these wedges and reuse them if
you have to transport your wine cabinet over a long distance.
• Arrange the electric power lead so that it does not come into contact with any of the cabinet's components.
• Install the stop at the back of the cabinet (see diagram).
This allows a space of 7 cm to be maintained between the wall and the rear of the cabinet. This space
allows your cabinet's power consumption to be optimised.
6
1
2
Picture 2
Picture 1