Troubleshooting - Arktic 271797 Gebrauchsanweisung

Maintenance
• Check the power cord for any damage from time
to time to avoid electric shock. Never operate the
appliance when the power cord is damaged. A
damaged power cord must be immediately by a
qualified and authorized technician.

Troubleshooting

If the appliance does not function properly, please check the below table for solution. If you are still unable to
solve the problem, please contact the supplier/service provider.
Problems
Appliance has no function.
Compressor does not work.
Compressor works, but no flake
ice is made.
indicator is on.
Indicator B is always on
Indicator B is on 3 times per 5s
Indicator B is on once per 5s
Indicator B is on 2 times per 5s
Water leakage
Stagnant water inside the ice
cube storage room
• Only a qualified technician and original spare
Possible causes
• Appliance is switched OFF.
• Not connected properly with the electri-
cal supply.
• Water shortage from the water supply
system.
• Container is full of ice.
• Refrigerant leakage
• The refrigerating system is blocked.
• Water shortage from the water supply
system.
• Water valve is damaged.
• Tap water pressure is too slow.
Gear motor is defective.
Hail device is not working.
Condenser fan is defective.
Ice level sensor is not working.
Water temperature sensor is not working.
Condenser sensor is not working.
• The water tube is damaged.
• The water inlet pressure is too high.
• The installation of drain tube is lower
than horizontal water level.
• The drain tube is blocked.
parts and accessories should be used to carry
out the repair and maintenance work. DO NOT
attempt to repair the appliance yourself.
Possible solution
• Switch ON the appliance.
• Check the connection with electri-
cal supply.
• Check the water supply system. If
ok, restart the appliance.
• Take out some ice.
• Contact the supplier.
• Check the water supply system. If
ok, restart the appliance.
• Contact the supplier.
• Be sure the tap water pressure is at
least 1kg/cm²
Contact the supplier
Contact the supplier
Contact the supplier
Contact the supplier.
Contact the supplier.
Contact the supplier.
• Change the water tube.
• Check and reduce the water inlet
pressure.
• Adjust the drain tube height.
• Change the drain tube.
EN
9