Arktic 271797 Gebrauchsanweisung Seite 7

Installation of the appliance
Attention: Any installation, maintenance and repair work should be performed by qualified and authorized
technician only.
• Check to make sure that the appliance is undam-
aged or complete delivery. In case of any damage
or incomplete delivery, DO NOT use the appliance
and contact the supplier immediately.
• Check that the accessories such as water sup-
ply hose, water drainage hose, 2 spare sealing
washers & ice scoop are included.
• Remove all packing material and protective film
(if applicable).
• Place the appliance on a level, steady and safe
surface which can supports the weight of the
appliance together with the flake ice produced
during use.
Connection to the water supply
Attention: The appliance should be connected to a cold drinkable water supply only. Otherwise, a cleaning
system or filter should be installed in advance.
• Connect one end of the water inlet supply hose
(13) to the 3 / 4" screw type connector of the wa-
ter tap supply so as to get the drinkable tap water.
Then, connect the other end of this hose to the
back of the appliance (9) by screwing clockwise.
Be sure to put sealing washers (15) in both ends
before connecting.
• Next, connect one end of the drainage hose (14)
using the rubber drainage cuff to the rear of the
appliance (10). Attach the other end to the sew-
age outlet / water container. The height of the
sewage outlet / water container must be situated
lower than the appliance, so that water can flow
out.
Note: The inlet water supply pressure range: 1- 8 kg/cm
over this range.
• Avoid expose to direct sunlight or direct source of
heat such as cooker, heat oven, etc.
• Make sure that a minimum of 15 cm distance is
kept around all sides of the appliance for ventila-
tion purposes.
• Place the appliance in such a way that the plug
is easily accessible and can be quickly removed
from its socket in case of necessity.
• Set up the appliance near water supply connec-
tion.
9
Power
Cable
. Pressure reducer should be installed if the pressure
2
EN
12
10
7