Power Supply Of Further Devices; Operation; Stand-Alone Operation; Master/Slave Operation - EuroLite LED TMH-W555 Moving Head Wash Zoom Bedienungsanleitung

1 Connect the device via the enclosed mains cable to a grounded mains socket.
2 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.

Power supply of further devices

The jack POWER OUT allows for power supply of further devices. To interconnect several devices, connect
the jack POWER OUT to the input POWER IN of the next unit until all units are connected. Matching power
cables with P-Con plugs are available as accessories. In this manner, up to 4 devices can be linked at
230/240 input voltage and up to 2 devices at 110/115 input voltage.

OPERATION

With the power switch, you can switch the device on and off. After you connected the effect to the mains, the
device starts running. During the Reset, the motors are trimmed and the device is ready for use afterwards.
The operating modes can be selected by means of the display and the control buttons. All settings remain
stored even if the device is disconnected from the mains.
The device has two operating modes. It can be operated in stand-alone mode via the control board or in
DMX-controlled mode via any commercial DMX controller and wireless via QuickDMX with the optional
available EUROLITE QuickDMX USB Wireless Transmitter/Receiver.

Stand-alone operation

In stand-alone mode, the device can be used without controller. Disconnect the device from the controller
and call up the internal program. Please refer to the instructions under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave-devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired Master mode "Slow", "Fast", "Sound" or "Manual" for the master device. Set the respective
mode "DMX" for all slave-devices. Please refer to the instructions under Control Board.
26/36 00133993, Version 1.0