STEPCRAFT M Serie Betriebsanleitung Seite 47

Unscrew the vision panel from the control cover.
Replace the vision panel with the tool changer switch unit (5). Pay
attention to the alignment of the switch. It should face the center
of the machine, thus allowing you to see the status signal of your
controller.
The tool changer switch unit (5) holds a three-pole
plug. Connect this plug to the tool changer board (1)
as shown. The pins are labeled JP3 .
It is important that the jumper stays connected exact-
ly as shown in the image!
Take the two-pole plug of the tool changer switch unit
(5) and connect it to the tool changer board (1) as
shown. The pins are labeled Mode 1.
The black cable has to face the edge of the tool
changer board (1). Pay attention to the polarity!
45