STEPCRAFT M Serie Betriebsanleitung Seite 41

Feed all cables coming from the Tool Magazine
through the small hole in the rear panel of your CNC
machine. Now feed all the air hoses through the large
hole in the rear panel of your CNC machine.
Fix the Schott connector (8), using the counter nut, in
the smaller hole of the control holding plate.
Secure the short 6 mm air hose (4) to the Schott
connector (8). Check for good fit by lightly pulling the
air hose.
Connect the 4 mm air hose (6) to the black side of the
intake air throttle (11). Check for good fit by lightly
pulling the air hose.
Take the tool change cover off the control holding plate (larger one) and drill a 6
mm hole right into the middle. Drill another 3 mm hole as shown.
8 8
4 4
39
8 8
11 11
6 6