STEPCRAFT M Serie Betriebsanleitung Seite 43

Now connect the cable pair to the 30V terminal on
the machine control mainboard.
Clamp the black cable to the minus, and the red ca-
ble to the plus terminal.
Connect the other end of the cable pair to the 30V in
terminal on the tool changer board (1).
Clamp the black cable to the minus, and the red cable
to the plus terminal.
Pay attention to the polarity!
In case you already own a STEPCRAFT LED-Set, con-
nect its power supply cables to the 30V out terminal
on the tool changer board (1).
Clamp the wire cable to the minus, and the red wire
to the plus terminal.
Pay attention to the polarity!
41