STEPCRAFT M Serie Betriebsanleitung Seite 38

Kapitel 2.3 vollständig überspringen, wenn Sie keinen Absaugadapter verwenden.
Insert the lifting arm (13) and then the compressed
air piston (12) into the middle hole of the lower part
of the Z-axis.
The two guide rods are to be inserted into the holes
on the left and right side. The thread has to face out.
Connect the black air hose with the piston.
Reconnect the tool holder to the Z-axis. The lifting
arm (13) and guide rods have to remain accessible.
Be careful not to squish the black air hose and make
sure it does not touch the threaded lead screw.
Fasten the four screws of the tool holder with a torque
of 3 Nm.
Slightly compress the arms of the lifting arm (13) to
fit them through the slit in the metal connector (10).
Attach the metal connector (10) to the guide rods
using both M5x12 screws. You may have to hold the
guide rods with a pipe wrench to keep them from
turning.
Now reattach the entire Z-axis. See chapter 3.2 to
3.4 (construction manual) of your CNC machine for
reference.
36