Operation - Hama TS39H Bedienungsanleitung

6. Operation

6.1. Connection to the measuring station
• Place both devices as close together as possible to connect the base
station and the measuring station with each other.
• After the batteries are inserted, the base station automatically searches
for a connection to the measuring station and carries out the initial
setup routine.
• If the device does not connect automatically, the manual search process
must be started on the base station.
Note
• Initial setup takes around 3 seconds.
• The radio symbol on the measuring station ashes during the
connection attempt.
• Avoid any operation of the buttons during this time! Otherwise, errors
and inaccuracies may occur in the values and their transmission.
• The process is nished as soon as the indoor and outdoor measurement
data are displayed on the base station.
• The measured value is automatically updated by the base device about
every 30 seconds.
• If the temperature value is outside of the measuring range, LLL.L (for
temperatures below the measuring range) or HH.H (for temperatures
above the measuring range) will be displayed in the temperature
indicator.
7