Hama 00176553 Bedienungsanleitung Seite 5

• If a door leaf or window juts out, the sensor can also be
attached to the side and the device secured flat to the
frame.
Warning - installation with adhesive
• All parts are suitable only for use indoors. Do not install
outdoors.
• Be aware that the intended mounting surface must be
free from dust and grease. Use a suitable cleaner from
a specialist retailer for this.
• Be aware that the adhesive pads are intended to be
permanent. Carefully pull the adhesive pad off the
mounting surface to remove it.
• Various environmental influences, such as moisture in
the air, sunlight, cold, etc., can impair the long-term
stickiness of the adhesive pads.
• Possible residue on the mounting surface after removal
of the adhesive pads cannot be ruled out!
4
4.4.3 Integrating devices into the Hama Smart
Home (Solution)
Now insert the two AAA batteries supplied, observing the
correct polarity. When you activate the burglar alarm, the
LED should briefly light up blue. Otherwise, please replace
the batteries.
• Now press the pairing button for 5 seconds. The LED
starts to flash red quickly. If it flashes slowly, press the
button again for 5 seconds.
• Open the app and sign in.
• Press the + in the top right-hand corner to add a new
device.
My Home
• Choose Sensors from the list.
• Next enter your WiFi password and confirm with NEXT.
• Now confirm that the sensor is flashing quickly by ticking
"Next step" and clicking on "Next".
• Your sensor is now connected.
Connecting Now