Safety; Appliance Description; Standard Delivery; Accessories - AEG DDLE Basis 13 Bedienung Und Installation

Installation – for qualified contractors
INSTALLATION

7. Safety

Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
Material losses
!
Observe the maximum inlet temperature. Higher
temperatures may damage the appliance. You can
limit the maximum inlet temperature by installing a
central thermostatic valve.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regula-
tions and instructions.
◦ The protection rating IP 25 (hoseproof) can only be
ensured with a correctly fitted cable grommet.
◦ The specific electrical resistance of the water must
not fall below that stated on the type plate. In a linked
water network, factor in the lowest electrical resist-
ance of the water (see chapter "Installation / Spec-
ification / Data table"). Your water supply utility will
advise you of the specific electrical water resistance
or conductivity.

8. Appliance description

8.1

Standard delivery

The following are delivered with the appliance:
◦ Wall mounting bracket
◦ Threaded studs, screws and rawl plugs for the wall
mounting bracket
◦ Installation template
◦ 2 twin connectors (cold water with shut-off valve)
◦ Flat gaskets
◦ Cable grommet (power cable from above / below)
◦ Screws / rawl plugs for fixing the back panel in the
case of water connection on finished walls
◦ Additional flow limiter in the cold water pipe (only
DDLE Basis 18/21/24)

8.2 Accessories

Tap
ADEo 70 WD Mono lever mixer tap with bath / shower
changeover
Stove connection set
Connection set for the power connection of the
DDLE Basis 11 and DDLE Basis 13
Installation accessories
Pipe assembly, undersink installation UT 104, connec-
tions: Finished walls, G 3/8, top. Water connections with
12 mm compression fitting.
Universal mounting frame
Mounting frame with electrical connections.
20
Pipe assembly for undersink appliances
You will need the undersink installation set if you use the
water connections (G 3/8 A) at the top of the appliance.
Pipe assembly for offset installation
You will need the pipe assembly with bends if you intend
to offset the appliance by 90 mm downwards from the
water connection.
Pipe assembly for replacing a gas water heater
You will need the pipe assembly if you are using the exist-
ing gas water heater connections (cold water connection
on the left-hand side DHW connection on the right-hand
side).
Load shedding relay (LR 1-A)
The load shedding relay for installation in the distribution
board provides priority control for the instantaneous water
heater when other appliances, such as electric storage
heaters, are being operated simultaneously.
ZTA 3/4 – Central thermostatic valve
The thermostatic valve is for central premixing, for exam-
ple on an instantaneous water heater with solar thermal
system.

9. Preparations

9.1

Installation site

Material losses
!
Install the appliance in a room free from the risk of
frost.
» Always install the appliance vertically and near the
draw-off point.
The appliance is suitable for undersink and oversink in-
stallations.
Undersink installation
1 Cold water Inlet
2 DHW outlet
Oversink installation
2
1 Cold water Inlet
2 DHW outlet
1
2
1