Troubleshooting - EINHELL GE-CM 18/33 Li Originalbetriebsanleitung

10. Troubleshooting

Fault
The motor fails to a) The connectors have become
start
b) The mower is standing in high
c) The mower housing is clogged
d) Safety switch is not inserted
e) Battery is not correctly inserted
The motor perfor- a) The grass is too high or too damp
mance drops
b) The mower housing is clogged
c) The blade is severely worn
d) Battery performance decrea-
Cutting is irregular a) The blade is worn
b) Wrong cutting height
Notice! For protection, the motor is equipped with a thermal switch which cuts out when the
motor is overloaded and switches on again automatically after a short cooling period
Anl_GE_CM_18_33_Li_SPK13.indb 26 Anl_GE_CM_18_33_Li_SPK13.indb 26
GB
Possible causes
separated from the motor or the
capacitor
grass
sing
- 26 -
Autogoods "130"
Remedies
a) Have repaired by the Customer
Service Center
b) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary
c) Clean the housing so that the blade
moves freely
d) Insert safety switch (see 6.)
e) Remove the battery and reinsert
(see 5.)
a) Correct the cutting height, change
the electronics setting
b) Clean the housing
c) Replace the blade
d) Check the battery performance
and charge the battery if necessary
(see 5.)
a) Replace or resharpen the blade
b) Correct the cutting height
23.09.2021 14:55:56 23.09.2021 14:55:56