Trouble Shooting; Possible Cause - Modster Flash XL Betriebsanleitung

Trouble shooting

Problem
Aircraft will not respond to
the throttlebut responds to
other controls.
Extra propeller noise
or extra vibration.
Reduced flight time
or aircraft
underpowered.
Control surface does
not move, or is slow to
respond to control
inputs.
Controls reversed.
-Motor loses power
-Motor power pulses
then motor loses
power.
LED on receiver
flashes slowly.

Possible Cause

-ESC is not armed.
-Throttle channel is reversed.
-Damaged spinner, propeller,
motor or motor mount.
-Loose propeller and spinner parts.
-Propellor installed backwards.
-Flight battery charge is low.
-propeller installed backward.
-Flight battery damaged.
-Control surface, control horn,
linkage or servo damage.
-Wire damaged or connections
loose.
Channels are reversed in the
transmitter.
-Damage to motor, or battery.
-Loss of power to aircraft.
-ESC uses default soft Low
Voltage Cutoff(LVC).
Power loss to receiver.
-Lower throttle stick and throttle trim to
lowest settings.
-Reverse throttle channel on transmitter.
-Replace damaged parts.
-Tighten parts for propeller adapter, propel-
ler and spinner.
-Remove and install propeller correctly.
-Completely recharge flight battery.
-Replace flight battery and follow flight
battery
instructions.
-Replace or repair damaged parts and adjust
controls.
-Do a check of connections for loose wiring.
Do the control direction test and adjust
controls for aircraft and transmitter.
-Do a check of batteries, transmitter, receiver,
ESC, motor and wiring for damage(replace as
needed).
-Land aircraft immediately and recharge flight
battery.
-Check connection from ESC to receiver.
-Check servos for damage.
-Check linkages for binding.
�
Solution