Calibriting The Scale - Lacor 61730 Gebrauchs- Und Instandhaltungsanleitung

1 - Push the M3 button and hold it down while the scale turns on.
Do not lift your finger from the M3 button until the display shows 7.0.
2 - Push the M6 button and hold it down until the display shows SetUP.
3 - Push the M6 button once to enter calibration mode. The display will show Cal-1 and 00.000.
4 - Use the • button to move around the digits on the display and the CE button to change the
value of the digit.
Example: If you use a weight of 5 Kg for calibration. Use the • button to move around the
digits until you reach the 00.00 value and push the CE button until it shows a value of 05.000.
5 - Push the M3 button once and wait until the display shows 000000.
6 - Put the reference weight (for example 5 Kg) on the scale. The display will show some internal
values and some internal values on the price display.
7 - Wait until the values shown are stable. Push the M3 button to confirm. Please wait until
the weight display shows "good" twice and then remove the reference weight from the scale.
The scale will reset automatically and finish calibration.
38
CALIBRATING THE SCALE