Technical Data - IFM Electronic ecomat 200 FS-1 Betriebsanleitung

9. Technical data

Voltage supply
Supply voltage AC/DC input
Supply voltage DC input
Voltage tolerance
Power consumption
Sensor inputs FS-1
Sensor types
Sensor supply
Load current sensor input
Current consumption sensor
Switch point for PNP pulse pick-up
Switch point for NPN pulse pick-up
Input frequency
Sensor inputs FS-1 N
Sensor type
Sensor supply
Switch point
Wire monitoring
Input frequency
Characteristic values
Accuracy of the frequency measurement
Power-on delay time
Reset/release inputs 1/2
External auxiliary voltage
Current consumption
Switch point for positive switching
Outputs
Relay outputs
Switching capacity
Relay switching times
Transistor outputs
Switching voltage/switching current
All manuals and user guides at all-guides.com
24 V DC; short-circuit and overload protected
300 ms (corresponds to the display refresh time)
externally supplied, short-circuit protected
110 ... 240 V AC/DC (50...60 Hz)
27 V DC (typ. 24 V DC)
-20 ... +10 %
AC/DC input: 5 VA / DC input: 3 W
PNP/NPN; NAMUR (24 V DC)
approx. 10 mA
max. 15 mA
> 12 V ON; < 5 V OFF
> 15 V OFF; < 8 V ON
max. 5 kHz
(min. pulse length 0.1 ms)
NAMUR (according to EN50277)
8.2 V DC
< 1.55 mA ON; > 1.75 mA OFF
wire break: < 0.1 mA
short circuit: > 6 mA
max. 5 kHz
(min. pulse length 0.1 ms)
< 1%
24 V DC
typ. 2.5 mA
> 14 V
2 change-over contacts, potential free
6 A (250 V AC); B300, R300
10 ... 20 ms (energising)
30 ... 40 ms (de-energising)
PNP switched
24 V DC (±20%) / max. 15 mA
FS-1 / FS-1N
MONITOR
35
PAGE