Herunterladen Inhalt Inhalt Diese Seite drucken

Fuxtec FX-EK700 Original Bedienungsanleitung Seite 111

40v akku multifunktionsschneider
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ORIGINAL BEDIENUNGFSANLEITUNG/ORIGINAL USER MANUAL/MANUAL D´UTILISATION ORIGINAL
During operation
Holding and controlling the tool
device can cause severe or fatal injury.
Always keep your balance and a secure footing to maintain control of your chainsaw.
Never work on a ladder, tree branch, or another unsafe surface. Never lift the device
above shoulder height. Do not bend forward too far. Use a lifting platform to work at the
height of more than 4.5 meters.
Special care is required when working on slippery surfaces (wet ground, snow) and on
steep, overgrown terrain. Watch out for hidden obstacles such as tree stumps, roots,
and puddles to avoid tripping. Remove fallen branches, undergrowth, and cuttings. Be
extremely careful when working on sloping or uneven ground.
Be extremely careful in wet and frosty conditions (rain, snow, ice). Interrupt work in the
event of wind, storm, or heavy rain.
Operating instructions
Warning!
Keep hands and feet away from the cutting tool to avoid the risk of injury. Never touch a
running cutting tool with any part of your body.
The saw-chain continues to run for a short time after you release the throttle stick
(inertia).
The acceleration of the engine while the blades are blocked causes the clutch to slip.
This can lead to overheating and damage to essential components (including clutch,
polymer housing component). This, in turn, can lead to a risk of injury due to running
blades despite idling adjustment.
If the chain is stuck, always switch off the engine before cleaning and make sure that
the chain is stationary.
FUXTEC FX-EK700 rev1
Always hold the device by the handles with both hands during
operation. Close your fingers and thumbs around the handles.
Place your left hand on the front handle and your right hand on the
rear handle on the throttle. This also applies to left-handed users.
Always keep your hands in this position to keep your saw under
control.
Never try to operate your tool with one hand. Losing control of your
111

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis