SUOMY TX-PRO TRACK-1 Gebrauchsanleitungen Seite 25

User's instructions User's instructions
RETENTION SYSTEM Double D-ring — Figure 2
Insert the free end of the strap into the rings.
Pull until the strap fits tightly around the jaw.
After doing this, it should be impossible to slide out the helmet;
verify that, by taking it from the back edge and rotating it towards
the front, the helmet cannot be removed and that it remains well
fixed on your head.
If the helmet tends to come off or it moves freely on the head, pull
the strap tight until the right pressure is reached and repeat test.
If after repeating the test you are not able to efficiently tighten the
retention system, do not use the helmet.
Only after the strap has been adjusted tightly, fix the end part of the
strap by fastening it with the press stud on the tongue. (figure 2).
The only function of the press stud fitted on the chin strap is to
avoid fluttering of the end part while riding. The fact the press stud
is fastened is no guarantee that the helmet has been positioned and
closed correctly: the correct fastening of the strap must be verified
exclusively through the operations described in the previous
paragraphs.
To release the retention system, unfasten the press stud and pull the
tongue to loosen the closure. Slide out the end part of the strap from
the «D Rings ».
Use the unlocking tongue only to remove the helmet!
Never unlock while riding.
If the retention system does not work correctly, do not use the
helmet and contact Suomy authorized personnel only.
C
N
Z
FIGURE 2
A
B
D
Q
P
R
S
N
O
EN
25