Winding; Control; Adjuster; Stopper - Flysurfer Infinity 2.0 Bar Bedienungsanleitung

02.04 Winding

32
EN Power the bar up all the way.
Fold both leader lines to the
middle of the bar and hold them
and the bar in one hand.
Wind the lines in a figure
eight tightly around the bar.
Use either a half hitch or the
bungie loops to secure the lines.
All manuals and user guides at all-guides.com

02.05 Control

The Infinity 2.0 Bar offers
the usual control functions:
Powering, Depowering, left
and right.
We recommend that eve-
ryone who does not know
how to control a kite take a
course at a qualified school
or instructor. e.g One of our
partner schools.

02.06 Adjuster

The Adjuster is used to change the
length of the front lines in relation
to the steering lines to adjust the
trim of the kite to the wind condi-
tions. The depower trim can be set
for the kite, even when it is flying.
To depower, pull the red tab.
The Adjuster will shorten itself and
the kite will be depowered more.
To power up, pull the black tab
down a bit and let it go. The Adjuster
will lengthen itself accordingly.
Be aware that, especially
on smaller kites, extreme
depowering will negatively
influence the control over
the kite.

02.07 Stopper

When the Stopper Ball is in
use, the bar can only slide up
as far as the stopper when
you let it go. The depower
range will be limited by this.
Only use the Stopper Ball if
you are an experienced kiter,
and never use it on or near
the beach or in gusty unpre-
dictable conditions.
The Stopper Ball is located
under the adjuster. Grab it with
one hand and slide it down to
where you want the bar to park.
To release the stopper, you can
either push it up with your hand
or push against it with the bar.

02.08 Untwisting

The Infinity 2.0 Bar untwists all
flying lines automatically which
guarantees the proper function
of the safety system even after a
lot of rotations in one direction.
33
EN