Handling; Unwinding; Attaching The Safety Leash; Hooking In - Flysurfer Infinity 2.0 Bar Bedienungsanleitung

02 HANDLING

02.01 Unwinding

30
EN When unwinding the lines from the
bar, lay them out loosely on the ground.
Let the lines run through your fingers
and check them for damage at the same
time. When the bar is not attached to
the kite, the sorting of the lines starts
at the bar. When it is attached to a
kite, the sorting goes from kite to bar.
All manuals and user guides at all-guides.com

02.02 Attaching the Safety Leash

The Safety Leash prevents the kite
from flying away and endangering
others after the Quick Release has
been activated or after unhooking
and letting go of the bar. Never use
the kite without the Safety Leash!
Open the Quick Release on
the Safety Leash by pushing the
red release handle away.
Attach the bottom end of the Safety
Leash to a suitable place on your har-
ness. Important: Make sure that the
leash cannot get caught on anything af-
ter release. Also make sure that where-
ver you attach the leash, that it is strong
enough to take the pull of the kite.
Push the metal pin through
the loop at the end of the tube.
Push the release handle up and
insert the metal pin into its hole.
Make sure that the release handle is
secured all the way onto the pin.

02.03 Hooking in

When hooking in, make sure
that the Quick Release is the right
way up, with the Flysurfer logo
visible on the release handle.
Secure the loop after hooking in with
the Chickenstick. Do this by inserting
the Chickenstick between the harness
hook and the end of the loop.
Clip on the shackle at the end
of the Safety Leash to the steel
ring of the Safety Endline.
To function properly, the Quick Release
should not be caked with dirt nor frozen.
To function properly, no lines should be
wrapped around the Quick Release.
31
EN