Operator's Responsibilities; Intended Operation; Inspections - BWT BEWADES blue 0.5 Einbau- Und Bedienungsanleitung

11

Operator's responsibilities

You have purchased a durable and service-friendly
product. However, this also entails obligations. For
a perfect function you must ensure:
● Intended operation.
● Regular inspections and service work.
In case of changes in water quality or flow rates,
the limits of use of the system must be checked.
Prerequisites for the function and safety of the
product are inspections, regular inspections (every
2 months) by the operator and a half-yearly (every
6 months) routine maintenance (EN 806-5) of the
entire drinking water installation. A further prerequi-
site for function and warranty is the replacement of
wear parts at the prescribed intervals.
11.1

Intended operation

The intended operation of the product includes
commissioning, operation, decommissioning and,
if necessary, recommissioning. Proper operation
of the product and the drinking water installation
requires regular checks, servicing and operation in
compliance with the operating conditions used for
planning and installation.
11.2

Inspections

(by the operator)
BWT recommends that the operator regularly car-
ries out and logs the following checks:
Water pressure:
If the pressure conditions change, the limits of use
of the system must be checked.
Water quality:
If the water quality changes (UV transmittance), the
operating limits of the system must be checked.
Flow rate:
If the flow rate (l/min) changes, the operting limits
of the system must be checked.
Operating status of the product:
Checking whether error messages were issued.
Tightness:
Checking whether water escapes from the system.
Contamination and calcification:
Check whether foreign particles or deposits influ-
ence the proper operation of the device.
Condition of the device:
Check whether there is damage and whether all
parts are in the intended place.
EN
25