Environmental Protection - Crown CT15233P Originalbetriebsanleitung

body tilt and turn at the same time, first set the tilt
angle and then the turn angle.
• Turn on the indicating laser 3 and LED lamp 18, if
your power tool is equipped with these functions�
• Set the workpiece and fix it using clamp 13�
• Turn on the power tool, allow saw blade 7 to reach
the full rotation speed�
• Smoothly pull the body down and make the cut�
While cutting, do not cross your hands and keep them
at a safe distance from saw blade 7 (see fig. 21).
• Turn off the power tool and wait until saw blade 7
stops completely�
• Lift the power tool body up smoothly�
Cutting with traversing (see fig. 20-21)
• Place the power tool on the worktable and prefer-
ably fix it with bolts or clamps.
• Loosen screw 27 and move the power tool casing
from retaining bar 8 until saw blade 7 reaches its posi-
tion in front of the machined workpiece (see fig. 20).
• Adjust the length of extension brackets 12 depend-
ing on the workpiece length�
• Set the desired cutting angles as described above�
Caution: if you are going to do the cutting with
body tilt and turn at the same time, first set the tilt
angle and then the turn angle.
• Turn on the indicating laser 3 and LED lamp 18, if
your power tool is equipped with these functions�
• Set the workpiece and fix it using clamp 13�
• Turn on the power tool, allow saw blade 7 to reach
the full rotation speed�
• In order to make a cut, lower the casing and move it
towards retaining bar 8� Do not crisscross your hands
and keep them at a safe distance from saw blade 7
while cutting (see fig. 21).
• Turn off the power tool and wait until saw blade 7
stops completely�
• Lift the power tool body up smoothly�
Groove cutting (see fig. 22-23)
• Loosen screw 55, move plate 54, tighten screw 55
(see fig. 22).
• Loosen lock nut 53�
• Set the required cutting depth with the help of bolt 52�
• Tighten lock nut 53�
• Cut the grooves, observing the described rules (see
fig. 23).
• When the work is finished loosen screw 55, return
plate 54 to its initial position, tighten screw 55 (see
fig. 22).
The manufacturer reserves the possibility to introduce changes.
Power tool maintenance / preventive
measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Replacement of the insert (see fig. 24)
Replace the worn or damaged insert 11 in due time�
• Turn off screws 56 (see fig. 24).
• Replace the worn insert 11�
• Tighten screws 56�
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 19�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com�
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
clamping packaging�

Environmental protection

Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging should
be sorted for environment-friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper
manufactured without chlorine�
English
Автотовары «130»
30