Overview Of Controls - Siemens SIDOOR AT40 Betriebsanleitung

3

Overview of controls

X1: Flat cable connector for the add-on modules
X3: Connector for switch mode power supply
X4: Voltage output 24 V / 0.4 A
X5: Input signal emergency power module
X6: Connector for input signals
● Input 1 (configurable function)
● Nudge
● Close
● Open
X7: Motor plug
X8: Connector for Service Tool and USB adapter
H401: 7-segment display for door status and event codes
S401: Learn run
S402: Service button OPEN
S403: Service button CLOSE
X14: Flat cable connector for relay module
(optional) or CAN module (optional)
X15: Flat cable connector for the terminal module
H1: LCD display
S1-S4: Operator buttons for terminal module
Figure 3-1 Overview of controls
Elevator door drive AT40
A2B00095270A-03, 01/2012
29