Herunterladen Inhalt Inhalt Diese Seite drucken

Ossur ICELOCK clutch 4H 214 Einbauanleitung Seite 7

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
FOR THERMOPLASTICS
I. Flatten distal end of Plaster Cast (3)
enough
to centrally attach Delrin Tooling Body (2).
Attach with nails provided or double-sided
tape maintaining original pin alignment
II. A small hole may be drilled from edge of
Delrin Tooling Body (D) through length of
Plaster Cast (3) to assure maximum
vacuum
III. Attach Lam/Therm Ring (4) to Delrin
Tooling Body (2) with Delrin Screw (1)
NOTE: Ensure that arrow (A) on
Lam/Therm Ring (4) is aligned in AP or
ML direction
IMPORTANT: If Clutch Mechanism (7) is removed during lifetime of lock, torque to 15Nm
(11 ft./lb)
ATTACHMENT PIN
Apply Loctite 410 or 411 onto threads (E) on Attachment Pin (10) and screw it into Locking
Liner. Torque Attachment Pin to 4Nm (3ft.lb). Put Protector Cap on Pin before donning liner to
prevent damage. Remove Cap before donning socket. Also available:
L-292003 Attachment Pin clutch, short w/cap (7 notches)
L-292005 Attachment Pin clutch, long w/cap (17 notches)
Note: Use attachment pins for ICELOCK 200 series only
T-wrench (9) supplied is specially designed to wind Push Button (8) on Clutch Mechanism (7)
when donning socket. Use of any other tool may result in over tightening.
• Rated up to 120kg (265lbs) - high activity level (K3)
• Limited one-year warranty
IV. Vacuum form thermoplastic. Ensure
proper forming, especially at distal end. It
is important that thermoplastic is at least
6 mm thick at distal end
V. Rough-cut and grind plastic in transverse
plane, stopping at spacer screws (B). DO
NOT grind any deeper!
VI. Remove spacer screws (B) and attach
Lock Body (5) with four long countersunk
screws (6). Use Loctite 410 or 411 and
torque to 12 Nm (9 ft.lbs.)
NOTE: Push Button (8) may be shortened
by cutting it with hacksaw
3

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

L-214000

Inhaltsverzeichnis