Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 57
INSTALLATION
7 Run the cables together with the flexible pipes. Fix them with
plastic bands.
Connect the extension cables to the correct terminal, as
shown in the picture. For more information refer to wiring
diagram.
Unit controller connection cable
OK
Electric heater connection cable
Thermistor connection cable
19
PMML0344B rev.0 - 04/2016
All manuals and user guides at all-guides.com
8 Levelling procedure

Indoor unit

Follow the same procedure explained in
unit alone (Without tank)
Installation and operation manual.
Domestic hot water tank
If it is necessary, adjust the height of the mounting foot as
follows:
?
Follow the process:
Extension wires
1 Loosen the locknut of the mounting feet which needs to be
2 Turn the mounting foot to extend the height (use the
3 When the mounting foot is in his end position, lock the
Hexagon and slot
for help in the
foot adjustment
Threaded shaft
3(A)
4(B)
30(N)
}
31(L)
5
6
on the
YUTAKI S80 indoor unit
N O T E
All the procedure must be done before filling the water tank.
Adjust only the necessary mounting foot of the DHW tank with the
foot locknuts and when the tank is in the final position (moving the
DHWT after levelling can make it uneven again).
Start with all four feet screwed in as far as possible (factory supplied
position).
Use two or more people for levelling procedure.
extended (using a wrench).
hexagon or slot designed for this purpose in the shaft end).
locknut. It may be necessary holding the foot to keep it from
turning while tightening the locknut. Use for this purpose the
hexagon or slot in the shaft end.
If it is needed to proceed with the levelling procedure with
a second foot (process 1 to 3), never work over one foot
at same time. When finish, all 4 locknut must be tightened
firmly.
process
Washer
Weld nut
Locknut
Foot
7 mm
Hold the foot
shaft to keep
Adjust the
it from turning
foot's height
(2 options)
as needed
(2 options)
10 mm
Extend
Take in
Installation of indoor
Loosen locknut
17 mm
Lock the foot
turning the
locknut

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Dhws200s-2.7h2eDhws260s-2.7h2e

Inhaltsverzeichnis