MA lighting MA 2Port Kurzanleitung Seite 37

Update without session
Do not use so-called Type U3 USB-sticks (with two physically drives on a single USB-stick) for firmware update.
 create an USB-stick with STICKMAKER – programm and installation programm 4port_v1.x.y.imgz. (free of charge
download from MA-web site)

connect USB-stick.

switch on MA 2Port (connect with a ethernet cable), short afterthere following instruction appears:
„Please press key for update/recovery"

press button MENU now.
Now following instruction appears
„Please press key for FORMAT".
Simultaneously for an few seconds a loading bar starts.

- When the button MENU is pressed within this few seconds, the MA Node will be reseted. And after
automatc reboot the IP address is set to 192.168.0.xxx (xxx means the last three digits of serial number of the
unit)
- When the button MENU is not pressed within this few seconds, the MA Node will be updated – all settings

remain.
 After instruction „Please remove USB stick for reboot" please remove the stick, MA Node starts booting
automatically.
MA 2/4 Port WM
Data
Transport
Safety
instructions
Safety and
environment
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
36