Display
The MA 2Port and 4Port Node WM display will only show the most important settings. For configuring a node, you
have to use a grandMA console.
After switching the device on, the display will show this menu (image shows 2 Port version):
Name of MA 2/4Port Node
DMX Output
IP – Address
Mode
Number of Session
Configuration of DMX-Ports
Universe
e.g. 2Port
e.g. 30 = frequency of DMX-output in Hz; max. 30Hz possible
e.g..192.168.0.244
MANET2 or ARTNET
e.g. Session 1 - MA 2Port Node is part of session 1
e.g. Session 0 = no session
e.g. Session 3 + areas OUT grey highlighted = no active session
In –
this port receives DMX
OUT – this port sends DMX
Flashing frequency of the green area corresponds to the
refresh quote between MA Node and console
OFF – this port is off
Universe number of respective ports 1 – 256 (shown in the graphic:
universe 1 and 2)
MA 2/4 Port WM
Data
Transport
Safety
instructions
Safety and
environment
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
34