Olivetti ECR 2350 euro Kurzanleitung Seite 5

5. CHANGE THE DECIMAL POINT POSITION
The decimal point setting is preset to the x.xx format. This format can be changed, as needed, to one of the other
settings below.
1. Turn the PRG key to the PRG position.
2. Type the status number [0, 1, 2 or 3] to select the desired format as indicated in the following table:
Status Number
0
1
2
3
3. Press the [-%/RA] key to set the new format.
4. Program another feature or exit the program mode by turning the PRG to the OFF position.
Example: Program the cash register so that two digits are left after the decimal point.
Type/Press:
[2] + [-%/RA]
6. CREATE A PRICE LOOK-UP (PLU)
1. Turn the PRG key to the PRG position.
2. Press the [Qty/Time] key. The message "PLU001 PRI" appears on the operator display and the number 001
is displayed on the left-hand side of the displays to indicate the first PLU number.
If you wish to change the PLU number from 001 to another number such as 30, type [030] and then press
the [PLU] key.
3. Type the [unit price] that you wish to assign to that PLU.
4. Press the appropriate [Department] key to assign the PLU to a Department from 1 to 20. Use the [Dept Shift]
key for departments from 21-40.
5. Press the [Qty/Time] key to program another feature or exit the program mode by turning the PRG key to
the OFF position.
Example: Create PLU 1 with a unit price of £2.69 assigned to Department 3 and then create PLU 320 with
a unit price of £5.00 assigned to Department 33.
Type/Press:
[Qty/Time] + [269] + [Department 3/23] + [320] + [PLU] + [500] + [Dept Shift] + [Dept 13/33] +
[Qty/Time]
Format
x
x.x
x.xx
x.xxx
3