After Each Use - Fakir LEXUS Benutzerhandbuch

Trimmer and remove hairs by shaking, blowing or using cleaning brush provided.

After Each Use

• Make sure the Trimmer is switched OFF and disconnected from the electrical outler.
• Remove the Trimming Comb and clean with the brush. Remove the cutting unit by
pushing against the teeth of the cutting unit (fig. 11) and rinse under warm tap water
(fig. 12A and 12B) or use the brush supplied. Dry with towel thoroughly.
• Place the cutting unit back by inserting the notch of the cutting unit into the guiding
slot (fig. 13).
Replacing The cutting Unit
• If your cutters become damaged or worn, do not continue using the Trimmer. Replace
cutters immediately.
• Open the cutting unit.
• Remove the old cutting unit by pushing against the teeth of the cutting unit (fig. 11).
• Insert the notch of the new cutting unit into the guiding slot (fig. 13).
• Push the cutting unit back onto the Trimmer until you hear a 'click' (fig. 14).
WARNING!
• Never immerse the machine in water or rinse under the tap. (Fig.15)
• Only the trimmer attachment can immerse in water or rinse under the tap separate
from machine (Fig.16)
12A
12B
23
EN