Trimming For 'Beard' Look; Trimming Without The Beard Trimming Comb; Cleaning - Fakir LEXUS Benutzerhandbuch

EN

Trimming For 'Beard' Look

Be certain Beard Trimming Comb is on Trimmer and use setting 1 (3/64in/1mm) to result
in a 'Beard' look.

Trimming Without the Beard Trimming Comb

Remove comb if you are:
• Defining hair lines
• Trimming nape of neck
• Removing single, unwanted hairs
• Be certain the Trimmer is in the OFF position.
• Remove the Beard Trimming Comb by pulling it off the Trimmer (fig. 8).
• Switch the Trimmer ON.
• Make well-controlled movements. Touch the hair/skin lightly with the Trimmer (fig. 9).
Be careful when you are trimming without the comb as when the Trimmer is turned on it
will trim every hair it touches.

Cleaning

• Clean the Trimmer after each use.
• Always switch Trimmer OFF, unplug and remove power supply cord from Trimmer
before cleaning.
• Never immerse the Trimmer in water or rinse under the tap.
• Do not use abrasive cleaning agents, scourers or aggressive liquids such as alcohol,
gasoline, or acetone to clean the Trimmer and attachments.
• Never clean, replace or remove Trimmer comb with motor ON.
• Do not apply pressure to cutters.
• Do not touch cutters with hard objects as this may damage them.
• Use a soft, dry cloth to clean Trimmer handle.
During Use
• If cut hairs have accumulated in the comb area, turn Trimmer off, pull the comb off
• If cut hairs have accumulated in the comb, turn Trimmer off,
remove the comb and blow and/or shake the hair out of the
comb (fig. 6). The selected trimming length setting will not
change when you do this.
22