Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Replacing the rechargeable battery
Caution! The rechargeable battery may only be replaced by a qualified electrician
who is familiar with the relevant regulations (e.g. VDE)!
• Check the rechargeable battery for correct function at regular intervals. The rechargeable
battery must be replaced after 4 years at the latest.
• Disconnect the electrical power supply at all phases. The mains supply line must be
de-energised.
• Remove the housing from the bracket.
• Open the housing to replace the rechargeable battery. To do this, loosen the screw on the
side of the housing. You can then remove the upper part of the housing.
• Remove the red and black cables from the PCB connector.
• The rechargeable battery is held with a reusable cable tie. Open the cable tie and remove
the rechargeable battery.
• Insert a new equivalent rechargeable battery and close the cable tie so that the rechargeable
battery is firmly seated. Connect the cables of the new rechargeable battery to the PCB
connector.
Illustration for information only. Rechargeable battery may vary.
• Place the upper part of the housing on the underside and tighten up the screw on the side
of the housing.
• Charge the new rechargeable battery for 24 hours.
Care and cleaning
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these
may damage the casing or cause the product to malfunction.
• Use a dry, lint-free cloth to clean the product.
• Perform a functional test at regular intervals.
Disposal
a) Product
Electronic devices are recyclable waste and must not be placed in household
waste. At the end of its service life, dispose of the product according to the relevant
statutory regulations.
Remove any inserted rechargeable batteries and dispose of them separately from
the product.
b) Rechargeable batteries
You are required by law to return all used batteries. They must not be placed in
household waste.
Contaminated rechargeable batteries are labeled with this symbol to indicate that
disposal in the domestic waste is forbidden. The abbreviations for heavy metals
in batteries are: Cd = Cadmium, Hg = Mercury, Pb = Lead (name on rechargeable
batteries, e.g. below the trash icon on the left).
Used batteries can be returned to local collection points, our stores or battery retailers.
You thus fulfil your statutory obligations and contribute to environmental protection.
Technical data
Input voltage/current ..................... 220 - 240 V/AC, 50/60 Hz
Rechargeable battery ................... 3.6 V 800 mAh Ni-Cd
Power consumption ...................... 2.2 W (by AC supply), 0.7 W (by rechargeable battery)
Ingress protection .........................IP20
Operating time of the
emergency light ............................3 hours (rechargeable battery fully charged)
Lighting ......................................... 15 LED pieces, white, not interchangeable
Operating conditions ..................... 0 to +40 ºC, < 90 % relative humidity
Storage conditions ........................ -10 to +50 ºC, < 90 % relative humidity
Dimensions (W x H x D) ............... 350 x 240 x 40 mm
Weight .......................................... 718 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capturing in
electronic data processing systems) requires prior written approval from the publisher. Reprinting, also in part, is
prohibited. This publication reflects the technical status at the time of printing.
Copyright 2019 by Conrad Electronic SE.
*1885110_v1_1019_02_hk_m_en
Werbung
Inhaltsverzeichnis
