Weidmuller UCV/AR Bedienungsanleitung Seite 29

SetupSequence(continued)
All manuals and user guides at all-guides.com
Alarms 1 & 2
Select
Coil energisation
Alarm type
Setpoint value
Deadband value
Timer delay
Coil energisation
Alarm type
Setpoint value
Deadband value
Timer delay
Alarm reset
sequence
Setpoint
security
2
Enable/DisableAlarms
Enable
AL=Y
Disable
AL=n
Note: alarm settings are only shown if they are enabled.
Normally energised
A1nE
Normally de-energised
A1nd
Low type (active below setpoint)
A1=L
High type (active above setpoint)
A1=H
Setpoint value
SP1=
e.g., 50.0 %
50. 0
Deadband value
db1=
e.g., 0.1 %
0. 1
Timer delay (set to 0 s to disable)
dL1=
e.g., 20 s
20
Normally energised
A2nE
Normally de-energised
A2nd
Low type (active below setpoint)
A2=L
High type (active above setpoint)
A2=H
Setpoint value
SP2=
e.g., 50.0 %
50. 0
Deadband value
db2=
e.g., 10.0 %
10. 0
Timer delay (set to 0 s to disable)
dL2=
e.g., 20 s
20
Generalalarmsettings
Automatic reset
nOr
Manual reset
rES
Setpoints fixed at setup
SECy
Can change setpoints
SECn
Alarmchannelone
Alarmchanneltwo
Toggle Accept
Toggle Accept
Toggle Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
Toggle Accept
Toggle Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
Toggle Accept
Toggle Accept