Installation - Weidmuller UCV/AR Bedienungsanleitung

Clearingtrippedalarms
All manuals and user guides at all-guides.com
You can acknowledge a tripped alarm by simply pressing the key for
that channel (ï for Alarm 1 or ENT for Alarm 2).
Displayingthealarmsetpoints
To check a setpoint, simply press the key for that channel (ï for Alarm
1 or ENT for Alarm 2). If the alarms are disabled the display will show
---- .
Adjustingthealarmsetpoints
To change a setpoint, hold down the key for that channel (ï for Alarm
1 or ENT for Alarm 2). You will then be able to change the value using
the arrows. Release the key to save the value.
Note: There are limits for the setpoint values that depend on the input
range setting and you cannot change the value if setpoint security is on.
•Installation
These units must only be installed by qualified staff in accordance with
the information given in this manual and all relevant national electrical
wiring and safet y rules must be followed.
Locate the instrument in an area that is free from dust, moisture and
corrosive gases.
PowerSupplyRequirements
Check the power supply against the model number before applying
power to the instrument. Micromann modules must be used with a
suitable mains Power Supply, ratings are as follows:
Voltage Range
100–132 V AC
200–264 V AC
12–50 V DC*
*Using a DC power supply that provides this voltage will comply with
the instrument's UL/CSA listing.
Nominal Voltage
110 V AC
240 V AC
24 V DC
Power
6 VA
6 VA
6 W (at 24 V DC)
Frequency
47-63 Hz
47-63 Hz
-
17