Werbung
AP 15 • AP 30 • AP 45
②
①
EN Press POWER button
• The air purifier is set to automatic
The air purifier will automatically
your air purified (Quiet, Med, High,
purification can be activated manually
②
PlasmaWave™ ON or OFF.
①
③
- 34 -
• Bedienung • Operation • Utilisation • Bediening •
• Istruzioni per l´uso • Funcionamiento •
"beep" is heard. For the first 3 to 4
minutes after turning the unit on, the
indicators will flash while the unit
measures air quality. Once the sensor
has calibrated, the lights will stop
flashing and the unit will, begin in
AUTO mode.
When the air purifier is turned on
again:
• Press button to start the air purifier.
operation.
sense the amount of impurities in the
air, and adjust the fan speed to keep
Turbo).
• You can switch to manual operation
by using the Speed button. By
pressing the Speed button again,
you can switch from Quiet to Med
and High up to Turbo.
• The highest fan speed for maximum
by pushing the Speed button several
times.
• By pushing the Auto button for 3
seconds you can switch the indicator
Operation with Remote control
Battery replacement
• Squeeze tabs of battery cover and
pull cover out of remote at the same
time.
• Insert battery as shown and close
battery cover.
• Always use 3V lithium battery
CR2025 into the remote control.
Storage Cradle:
The remote control has a separate
wall-mountable storage cradle that can
be conveniently attached to any wall
using a screw.
until short
Werbung
