TFA SPOT Bedienungsanleitung Seite 13

TFA_No. 30.3030.01V2_Anleitung
SPOT – Wireless Thermometer
Transmitter
D: Display (Fig. 3):
D 1: Channel 1,2,3
D 3: Battery symbol for the transmitter
E: Housing (Fig. 3):
E 1: Battery compartment
E 3: Indentations for the holder for wall mounting
F: Buttons in the battery compartment (Fig. 3):
F 1: TX button
6. Getting started
6.1 Insert the batteries
• Place the instruments on a table at a distance of about 1.5 meters from each other. Avoid being close to
possible sources of interference such as electronic devices and radio equipment.
• Open the battery compartment of the transmitter and insert two new AA 1.5 V batteries, polarity as illus-
trated. All LCD segments will be displayed for a short moment. The display shows the temperature. The
switch is set to channel 1.
• Close the battery compartment.
• Open the battery compartment of the base station.
• Insert two new AAA 1.5 V batteries, polarity as illustrated. All LCD segments will be displayed for a short
moment. The indoor temperature appears on the display.
• Close the battery compartment.
6.2 Reception of outdoor transmitter
• The base station will scan the outdoor temperature for 60 seconds and the reception symbol flashes
24.08.2021 9:55 Uhr Seite 13
D 2: Transmission signal
D 4: Outdoor temperature
E 2: Holder for table standing
F 2: 1 2 3 switch for channel selection
– 24 –
SPOT – Wireless Thermometer
• If the reception is successful, the outdoor temperature and the reception symbol appear steadily on the
base station display.
• If the reception of the outdoor temperature fails, "- -. -" remains on the display. Check the batteries and try
it again.
• You can also activate the reception manually. Press and hold the +/CHANNEL button on the base station for
three seconds. The reception symbol for the outdoor transmitter will be flashing.
• Press the TX button in the transmitter's battery compartment. The transmission of the outdoor data takes
place immediately and if the reception is successful, the outdoor temperature appears on the base station
display.
6.3 Reception of the DCF frequency signal
• After the reception of the outdoor values, the clock will now scan the DCF frequency signal and the DCF
symbol flashes on the display.
• When the time code is successfully received after 3-10 minutes, the radio-controlled time and the DCF
symbol will be shown steadily on the display.
• The DCF reception always takes place at 1:00, 2:00 and 3:00 o'clock in the morning. If the reception is not
successfully received, further attempts will be taken at 4:00 and 5:00 o'clock.
• You can also activate the DCF reception manually. Press the +/CHANNEL and the SET/MAX/MIN button at
the same time for 3 seconds. The DCF reception symbol will be flashing.
• Interrupt the reception by pressing and holding again the +/CHANNEL and the SET/MAX/MIN button at the
same time. The DCF reception symbol disappears.
• There are 3 different reception symbols:
flashing symbol – reception is active
solid – reception is successful
no symbol – no DCF reception
– 25 –