Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
STEP 3
1.
Loosen the locking knob (18) and remove it
from the rear opening tube. Insert the saddle
support tube (7) into the rear opening tube and
then tighten the locking knob when the saddle
support tube is at the desired height.
2.
Place the saddle (8) on the saddle support
tube (7) of the saddle support tube. Thread the
previously locked L-shaped handle through
the saddle support tube and onto the saddle.
Ensure that the saddle is in the orientation
shown below.
3.
To secure the saddle, there are two hex nuts
on the underside of the saddle. Just tighten
one of the hex nuts with the spanner to lock
the saddle in position. If the hex nut is not
tight enough, the saddle will turn in different
directions and the angle will change when you
sit on it.
4.
Loosen the lock knob (18) and insert the
handlebar support tube (9) into the main frame
opening tube. Adjust the tube to the desired height and tighten the knob when the handlebar support tube
is in the desired position.
STEP 4
1.
Separate the nut, washers and bolt from the L-shaped nut (12), place the handlebar (10) on the handle
support tube.
2.
Insert the L-shaped locking knob through the handlebar and through the handle support tube.
3.
Tighten the nut to the end of the bolt. Turn the L-shaped locking knob counterclockwise to loosen and slide
the handlebar forward or backward. Turn the L-shaped lock knob clockwise to lock the handlebar in the
current position and tighten the bolt with the washer on the bottom of the L-shaped lock knob (12) with the
supplied screwdriver.
12
12
12
11
11
11
9
9
9
8
12
18
10
10
10
13
13
13
1
1
1
43
43
7
25
25
25
BESP-500
9
18
1
14
14
14
15
15
15
EN
Werbung
Inhaltsverzeichnis
