Installation Procedure - Kenwood KNA-TM320 Installationshandbuch

Installation Procedure

1. To prevent short circuits, remove the key from the ignition and disconnect the
- terminal of the battery.
2. Make the proper input and output cable connections for each unit.
3. Connect the wiring harness cables in the following order: ground, battery,
ignition.
4. Connect the wiring harness connector to the unit.
5. Install the unit in your car.
6. Reconnect the - terminal of the battery.
7. Turn your car's ignition ON.
8. Remove the Map disc out of the navigation unit and insert the Map disc which
is provided in the package.
9. Press the reset button of the navigation unit.
Accessories
A ..........2
D ..........1
The use of any accessories except for those provided might result in damage to the
unit. Make sure only to use the accessories shipped with the unit, as shown above.
2 English
B (ø4x16 mm) ....4
E ..........1
C (M3x8 mm) ....4
F ..........1