Installation And Connection - Kenwood KCA-R100 Bedienungsanleitung

Installation and Connection

Recommended installation position
• Install the device in a position where it will not block the view of the driver.
• Install the device within the wiping range if equipped the wiper.
Caution
When passing the power cord through the front pillar or another part, observe the
points below when performing the wiring work.
Wire the power cord farther forward or farther rearward than the airbag so that it
•
does not interfere with the airbag.
• In the case of a vehicle in which the pillar cover is fixed in place with special
clips or the like, the clips may need to be replaced after you remove the pillar
cover. For how to remove the pillar cover, the availability of replacement
parts and other information, contact the vehicle dealer.
• Fix the power cord in place with commercially available tape or the like so that
it does not interfere with driving.
Rear windshield
04