Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.
After 5 minutes channel searching, it will turn to DCF signal reception
automatically.
5.
Radio Controlled function, the current time & date automatically synchronized
with the time signal transmitted from Germany (DCF77).
Note:
If no display appears on the LCD after installing the batteries, press the [ RESET ]
key by using a metal wire.
You may not receive the DCF77 and wireless sensor(s) signal immediately. Due
to the atmospheric disturbance, the best reception for DCF often occurs
during night time.
Install the table stand
The unit is designed for desktop or wall mount for easy viewing. The following step is
for table stand installation.
Step 1
Set LCD display viewing angle
Press [ DOWN /MOON] button in normal mode to adjust LCD viewing angle to fit
table stand or wall mount situation.
Use the LCD backlight
In normal mode, press [ SNOOZE / LIGHT ] button to turn on backlight for 5 seconds.
Pairing additional wireless sensor/s (optional)
This console can support up to 3 additional wireless thermo-hygro sensor(s). You can
press [ SCAN ] key to search the corresponding channel's sensor manually. Once
your sensor paired up, the sensor signal strength indicator and weather reading will
appear on your console display.
Note:
The additional wireless sensor(s) is not included
Select CH 1, 2 or 3 in the wireless sensor
Please check the additional sensor's user manual for more detail of the
installation.
View multiple wireless sensor channels (optional)
1.
In normal mode, press [ UP / CH ] key to switch the display between CH 1~3.
2.
In normal mode, press and hold [ UP / CH ] key for 2 seconds to enter auto-
cycle mode, After a confirmation tone, it will alternately display the CH 1~3 at 4
second intervals.
3.
During auto-cycle mode, press [ UP / CH ] key again to stop auto-cycle mode
and display the current channel.
Reception of radio-controlled signal
The time and date are radio-controlled. The current time and date are
automatically synchronized with the time signal transmitted from Germany
(DCF77).
When used for the first time (after inserting the batteries or pressing the [ RESET ]
key), the clock will start to receive the RC signal after 5 minutes with the signal
strength indicator flashing. You can also press [ RCC ] key to receive the DCF signal
once.
DCF77 signal reception icon
The signal indicator shows signal receive status. The signal receiving status
could be classified into 3 types:
No DCF signal received
Note:
Every day the weather station will automatically search for the time signal at
2:00, 3:00 and 4:00 .
Always place the unit away from interfering sources such as TV set, computer,
etc. Avoid placing the unit on or next to metal plate.
Closed area such as airport basement, tower block or factory is not
recommended. Do not start reception on a moving vehicle or train.
User can permanent disable or enable the RC function by press and hold the [
RCC ] key for 8 seconds. OFF appears when the function was disabled.
Daylight saving time (DST)
This clock has been programmed to automatically switch when the daylight saving
time is in effect. User can disable the DST function in time and calendar setting mode.
Note:
DST AUTO/OFF setting only available when RCC function is ON.
Time & calendar setting and display
Manual time & date setting
In normal mode, press and hold [TIME] key for 2 seconds to enter date and time
setting mode.
Press [ UP / CH ] or [ DOWN /MOON] key to adjust the setting.
Step 2
Receiving DCF signal
EN3
Step 3
Received DCF signal
Werbung
