Pioneer AVD-W6000 Anleitung Seite 35

4. Paste the mounting base onto the
dashboard.
Make sure the surface is free of mois-
ture, dust, grime, oil, etc. before affix-
ing the mounting base.
Dashboard
Peel off the protective sheet.
Note:
• The mounting base contains a strong
adhesive and may leave a mark on the
dashboard if it is removed.
5. Fasten the mounting base onto
the dashboard with the tapping
screws.
Tapping screws
(3 × 12 mm)
Dashboard
CAUTION
• Before drilling any mounting
holes, confirm that the screws
will not interfere with any of the
vehicle's operating systems (such
as the fuel line, brake lines, elec-
trical wiring, etc.).
6. Adjust the display vertical posi-
tion and display angle.
In order to stabilize the display, adjust
the display vertical position so that the
bottom of the display base contacts the
dashboard. Adjust the display to a
good angle for viewing.
If you turn this knob to the left, you
can adjust the vertical position of
the display.
Dashboard
If you turn this knob to the left, you
can adjust the angle of the display.
Note:
• After you have adjusted the display vertical
position and angle, turn the knobs clockwise
to fasten the display in place.
34