When The Display Is Installed In The Front; Before Installing And Fixing; Before Affixing The Adhesive Tape - Pioneer AVD-W6000 Anleitung

• If this product is installed in a place where it is visible to the vehicle's driver,
you MUST always set the [DISPLAY SETTING] to the [FRONT] setting.
Failure to do so could result in distracting images being potentially visible to
the driver while the vehicle is in motion.
If this product is installed in a place where it is not visible to the vehicle's
driver, then you may choose the [REAR] location setting.
Use of this product is subject to any local laws regarding placement or use.
PIONEER Corporation cannot accept any liability for any problems, dam-
age or loss incurred as a result of the product being used with an incorrect
setting or in violation of any local laws.
• To ensure proper installation, use the supplied parts in the manner specified.
If any parts other than the supplied ones are used, they may damage internal
parts of the unit or they may work loose and the unit may come off.

When the Display is Installed in the Front

• To ensure safe driving, be sure to install the display in a position that meets
the following conditions.
* Where it does not obstruct the driver's forward vision.
* Where the front of the car is within the driver's field of vision when look-
ing at the display.
* Where the display does not protrude above the front of the hood as viewed
by the driver.

Before Installing and Fixing

• Make temporary connections first to check that the unit and system are working properly.
• Press with the tip of a ball-point pen or similar object, when a connection is completed.

Before Affixing the Adhesive Tape

• Make sure the surface is free of moisture, dust, grime, oil, etc. before affixing the tape.
32