Programming
SKT-2-01
4.4 Info
Select menu item "Info" and confirm with OK.
The current software as well as the serial
number of the module are displayed during 2
or 3 second.
Fig. 11
Info
4.5 Configuration
Select menu item "Configuration" and confirm
with OK.
Fig. 12
Configuration
The configuration menu is opened.
Fig. 13
Configuration menu
4.5.1 Audio language
Fig. 14
Audio language
With VOL
selected (the broadcasting service must offer
these languages).
Confirm by pressing OK.
Page 10
/ VOL
preset languages are
© AXING AG – state of the art: August 2012 – Reserving change in design and type
If ALL is selected instead of a language code,
!
all languages offered by the channel are
transmitted and the language can be selected
on the DVB-T receiver (recommended setting).
4.5.2 LNB supply
The LNB supply can be switched off
Fig. 15
LNB supply
Press the VOL
/ VOL
want the LNB supply to be switched on or off.
Normal = LNB supply on
Power off = LNB supply off
!
•
If a Quattro LNB is connected, at least one
LNB duct must be supplied with power, the
others can be switched off. (recommended
setting)
•
If an input distributor is used, the left duct
of the first module on the front left side
always is responsible for the power supply
of the LNB connected to this input distribu-
tor. In this duct, the LNB supply must be
set to Normal. All the other SKT 2-01 con-
nected to this input distributor must be set
to "No voltage" under LNB supply.
•
With the multiswitch, all ducts must be set
to "Normal".
4.5.3 Start UP video output
Fig. 16
Start UP video output
Press the VOL
/ VOL
to proceed after a voltage interruption.
modulator menu = basic setting
After a power break or if inside the menu no
other settings are done, the modulator menu is
shown on analogue output.
For error free displaying of high definition
programs the setting modulator menu should
be used.
!
High definition programs can not be shown via
analogue output.
keys to select if you
keys to select how