Preparation; Duct (Left Or Right); Start Window; Main Menu - axing SKT 2-01 Betriebsanleitung

4.1 Preparation

During initial operation and all programming of
the SKT 2-01, a monitor must be connected to
the corresponding AV outputs.

4.1.1 Duct (left or right)

Push the programming selection switch to the
left or the right to program the left or right duct
of the module.
For operation, the switch must be
positioned in the center after programming.

4.1.2 Start window

When the SKT 2-01 is supplied with energy for
the first time, the start window appears on the
monitor.
Fig. 7 Start window
Serial number and software version of the
respective channel line is displayed.
The set output channel is shown on the display
of the SKT 2-01.
Fig. 8 Pre-programming
If a transponder is already assigned to the
module duct, the transponder shows
information about the SAT position, frequency,
polarization, symbol rate, FEC, VPID of the
current program.
If the transponder is not assigned, the start
window is displayed.(see Fig. 7).
© AXING AG – state of the art: July 2012 – Reserving change in design and type

4.2 Main Menu

After pressing the menu key, the main menu
opens.
Fig. 9 Main Menu
In the menu you can move the cursor upwards
or downwards by pressing CH
By pressing OK you can select a menu item.
The preset settings of the individual menu
items can be selected by means of the VOL
/ VOL keys.

4.3 Menu language

Fig. 10 Menu language
Select the menu item "Menu language" and
confirm with OK.
The desired language can be selected by
means of the VOL / VOL
Confirm by pressing OK.
Programming
SKT-2-01
/CH .
keys.
Page 9